#i2cconfiguration

[adafruit]

ICN6211 DSI demo with 5" 800x480 display on a Raspberry Pi 🔌📟👨‍💻

To test out the icn6211 library and circuit configuration, we've connected up a 5" diagonal 40-pin 800x480 display . It was pretty sweet when the desktop image appeared! one of the nice things about using the MIPI/DSI interface is all the GPIO and HDMI ports remain unused, and the ICN is waaay cheaper than an HDMI-to-TFT converter chip. We have another rev we're going to spin that makes I2C configuration a little easier

[adafruit]

USB2422 configurable USB Hub chip

The Microchip USB2422 is kinda neat, its a low cost USB hub with EEPROM you can connect to I2C to configure. We thought it would make a nice little breakout for whenever you have a USB port but you sorta wish you had two! Maybe even embed in some hardware! We just made a couple USB hub breakouts with the CH334F ...

but this board might be nice if you want more configurability & control: the stemma QT connector on the end is what you can plug into to program it. we designed rev A of this board in 2021 and then it got slammed by part shortages, now its back in stock so we can revisit this design!