#FluidLevels

[discoverhowitworks]

How To Check Automatic and Manual Transmission Fluid Levels

Checking the transmission fluid levels in your vehicle is an important part of routine maintenance. Proper fluid levels can help extend the life of your transmission and prevent costly repairs. Here's how to check the fluid levels for both automatic and manual transmissions. Automatic Transmission Fluid: - Start your vehicle and let it run for a few minutes to warm up the transmission fluid. - Locate the transmission fluid dipstick, which is usually located near the back of the engine. - Remove the dipstick and wipe it clean with a cloth. - Reinsert the dipstick fully and then remove it again to check the fluid level. - The fluid level should be between the "Full" and "Add" marks on the dipstick. If the level is low, add fluid until it reaches the "Full" mark. Be sure to use the type of fluid recommended in your vehicle's owner's manual. Manual Transmission Fluid: - Locate the transmission fluid check plug, which is usually located on the side of the transmission. - Remove the check plug and insert your finger into the hole. The fluid should be level with the bottom of the hole. - If the fluid level is low, add fluid until it reaches the bottom of the hole. Again, be sure to use the type of fluid recommended in your vehicle's owner's manual. - Replace the check plug and tighten it securely.

It's important to check your vehicle's transmission fluid levels regularly to ensure proper performance and prevent potential damage. If you notice any leaks or abnormalities with the fluid, it's best to have your vehicle inspected by a professional mechanic. By following these simple steps, you can help keep your transmission running smoothly for years to come. Read the full article

[foulladypanda]

STEAM TESTING SOLUTIONS

[unicollc]

Benefits of Unico ESP Drives

Instant and accurate measurement of casing fluid level is critical while using Electric Submersible Pumps for oilandgas production. Unico LLC ESP drives are capable of measuring pump fluid flow, pump intake pressure, and casing fluid level without requiring any down-hole sensors. It is achieved by controlling only the base pump head and pump intake depth that is readily available from well setup data. This method of controlling fluidlevel completely protects the pump, maximizes production for changing inflow characteristics, avoids lost production due to underload shutdowns, and minimizes the recovery time from power outages.