civildesign

[civildesign]

This course has been prepared assuming that the students who enroll in this course are completely new to this software. The main purpose of this course is to make the students familiar with the ETABS so that they can easily take the higher level courses without having confusions. Basic level of knowledge is given in this course as this course is  for complete beginners. In this video, I have talked about the analysis of simply supported beams. After that, I have talked about the modelling of a simple structure. Concept of mass source and how to define the mass source properly has also been explained in this course. Defining the load combinations and load patterns have also been explained. Finally,  the method to do structural analysis and design have been explained.

[civildesign]

How to design a building in ETABS in 60 minutes.

Modeling, Analysis, Design and Detailing of a G+5 building in ETABS. Watch the COMPLETE video at highest possible resolution, only then you'll understand what this video is all about. Preferred resolution 720p.

 (I didn't miss 12th point, it's a typo) 

 For Load Calculation :

IS 875 (Part 1) - Dead Loads 

IS 875 (Part 2) - Imposed Loads (Live) 

 IS 875 (Part 3) - Wind Loads 

IS 875 (Part 4) - Snow Loads 

IS 875 (Part 5) - Special Loads and load combinations 

IS 1893:2016 - Earthquake Loads 

IS 456:2000 - Concrete IS 800:2007 - Steel