icwmachine

[icwmachine]

MJ105A Manual Tenon Machine ICW WOODWORKING MACHINE SINCE 2004

[icwmachine]

CNC Nesting Machine No-dust Working 4x8 / 4x9 /6x9/7x9 /5x10

The CNC Nesting Machine Center automatically labels on the sheet,

and then it will load a 4x8 / 4x9 /6x9/7x9 /5x10 sheets etc， from a pallet by way of a scissor lift located at the rear of the CNC Nesting

machine. A movable gantry system equipped with suction cups using retractable guide rails and stops on the table safely and accurately guides the material sheet onto the CNC platform. Once the sheet is placed, the vacuum hold down automatically and operator starts the cut cycle for the CNC to execute. At the same time, machine will start to label on next sheet. After the sheet is fully processed, it is then pushed off to a conveyor table at the front end while another finished labeling sheet is simultaneously loaded from the rear of the machine again. During this whole process the residual dust or chips that are not picked up from the dust collector are swept off the table and conveyor into various chutes keeping the work cell clear of dust and debris. Upon completion, the individual parts are labeled by the operator through an integrated bar code system. This facilitates clear identification of the finished parts for quick and easy assembly later on.

[icwmachine]

VH-M416GJ Four Side Planer

[icwmachine]

MJ105A Manual Tenon Machine ICW WOODWORKING MACHINE SINCE 2004

[icwmachine]

VH-M416GH Four side planer V-hold