brightchen-blog

[brightchen-blog]

A piece of construction hardware veteran

Share the application and production knowledge of building hardware scenarios

[brightchen-blog]

Containers need to be loaded on the first day after the May Day holiday.

The factory began to get busy again after a holiday

[brightchen-blog]

Although the plate with lock technology is very mature, it still needs to go through our final inspection to ensure that the size and parameters meet the customer's requirements before mailing it.

This should be the last sample sent before the May Day holiday.

[brightchen-blog]

Door Hinge Vertical and Lateral Wear Test

At the conclusion of the cycle test, vertical and lateral wear shall notexceed the values given below. Angle of opening shall be the same forfinal measurements as for original measurements within 2 degrees. Vertical measurement is betweenadjacent jamb and door knuckles. Lateral measurement is between inner edge of jamb leaf and adjacent door knuckle.

#doorhinge #doorhardware #doorlock #woodendoor

[brightchen-blog]

[brightchen-blog]

Growth is the process of breaking the perception & discovering the truth. Your beliefs & goals are constantly updated with your knowledge

[brightchen-blog]

[brightchen-blog]

Cooperation is very important

[brightchen-blog]

Technology is the primary productive force

[brightchen-blog]

Quality is the life

[brightchen-blog]

Our design philosophy combines popular styles, functions, application scenarios and factory manufacturing techniques. While meeting the customer's design application requirements, we will give suggestions for improvement and help customers control costs

[brightchen-blog]

You are my sunshine

[brightchen-blog]

1. Cycles per Minute - All Grades:

20 + 1 for door weighing up to 175 lbs (79 kg)10 to 20 for doors weighing 175 1bs. (79 kg) to 300 lbs (135 kg)Up to 10 for doors weighing over 300 lbs (135 kg)

2. Actuator for Operating Door.

Cycle Counter Mechanical or electrical counters which register one cycle for each complete opening4.9and closing of test door.

3. Instruments Precision instruments accurate within 5% suitable for measuring lateral and verticalwear.

[brightchen-blog]

Where there is a will, there is a way

[brightchen-blog]

Where there is a will, there is a way

[brightchen-blog]

Door hinge test requirements

1. Jamb

A rigid, vertical steel jamb that is not mortised for hinges with a minimum thickness of 1/4 in(6.4 mm) shall be erected to hang the test door, Hinge mounting surfaces shall lie in the same plane and beplumb. Door stops or latching devices shall not be used. The door shall swing freely through a 90 degree testarc.

2. Blocks

Steel jamb mounting blocks 1/4 in (6.4 mm) minimum thickness shall be provided for each ofthe hinges. They shall be of such rectangular dimensions as shall accommodate the leaves of the specimensand shall be over-sized to the extent that three 1/2 in - 20 x 3/4 in (12.7 mm - 20 x 19 mm) hexagon head capscrews plus lock washers shall be applied to each block making it tight to the jamb (see 8.2). Holes for thesecap screws shall be of such diameter as shall permit 1/8 in (3.2 mm) adjustment in all mounting planedirections before tightening.

[brightchen-blog]

Door hinge TEST EQUIPMENT（1）

Door requirement

Provide a door structure of a conventional wood or metal door that is not mortised for hinges, or4.1a skeletonized structure having an equivalent center of gravity in all directions after weights are appliedHinge mounting surface of a door shall be a continuous steel strip with a minimum thickness of 1/4 in (6.4mm). The dimension from the hinge axis to the edges of the mounting surfaces and to a plane parallel to thedoor face through the center of gravity of the door, full mortise hingesTest door width is 36 in (914 mm).